****** - Verified Buyer
4.5
Fit like a glove!Did not fit our Payne furnace inducer mounting holes. Have to return. However seller now says we must pay shipping and pay restock fee of up to 50%. I ve been waiting on Seller or Amazon to reply to me. The ad says free return shipping and may be returned within 30 days. I m returning within 4 days. Unused. Not installed. Mounting does not match. Just off a bit.The product arrived quickly and was good quality. There were a few small issues. Just like reviewers below, the spacers from the original unit didn't fit in the new fan. They needed to be ground/shaved down to fit. Also, one of the isolation mounts was not connected to the motor. Easy fix, but I didn't notice it until after the motor started up and was bouncing around. Once fixed the install was straight forward and worked great. Good value and 4 stars overall.Came a lot quicker than estimated. Was exactly as described and a direct fit replacement for existing part. I watched a YouTube video to ensure I had all the steps down. Install took 30 minutes start to finish (remember to disconnect the drain hose and transfer the drain plug and plastic spacers to the new unit). Cost me literally 25% of what a professional quoted to replace the part. Very happy with it.Product installed just fine. Works great. I was looking at having to spend nearly $2000 for a new furnace, but this makes the furnace run just like new - would recommend anyone considering this to double-check the heat exchanger for leaks as if there are leaks you need a new furnace.I purchased this unit for a Bryant furnace. Installed according to instructions. After running the furnace for an hour I noticed there was water coming out of the bottom of the furnace. I assumed it was condensate. After further investigation it was leaking from the seam of the two pieces that were put together with a small 1/8th inch round rubber gasket that was twisted and pinched. After removing the unit and disassembled it,I had to chalk the perimeter with silicone to seal it. And then reinstall. needless to say I was not happy with the unit.This inducer blower assembly was an exact fit, of good quality, and runs quietly. It took me about two total hours to replace, including get-ready time and clean up.Installed in my Amana weather maker furnaceFit perfectlyBlack and white wires were switched in the connector but it’s an AC motor so didn’t bother with switchingMuch quieter operation of my hVac now!This product arrived a week earlier than estimated & just in time; my old part was failing. Installation was easy, except for lining up the screws. With care & patience, it was installed in about an hour. Afterwards, my furnace was back up & running. Outstanding product & customer service.Works great easy install. Very quiet.
